Hi
@smischny
I've tested the generic VB50Tx with the WeAct MiniH750VB using PA9/PA10.
I have no garbage with the default clock config.
Here the example used:
Code: Select all
const char lorem[]="Lorem ipsum dolor sit amet, consectetur adipiscing elit. Quisque elementum ullamcorper velit in pretium. In quis tellus eros. Duis neque diam, sagittis et condimentum a, consequat non nibh. Quisque ut pellentesque eros. Cras accumsan velit ex, in porttitor ligula malesuada at. Sed suscipit tellus nibh, et aliquam magna interdum at. Nam viverra magna augue, vitae dapibus justo commodo ultrices. Donec faucibus nulla quis felis iaculis volutpat. Nunc a dui aliquet purus luctus auctor. Ut tristique nisi et purus hendrerit, sed auctor orci mollis. Suspendisse placerat turpis elit, in tincidunt velit dapibus in. Vivamus eu mi sed elit scelerisque finibus. Curabitur ullamcorper sit amet risus eu mattis. Sed a mollis sem. Curabitur egestas convallis sapien. Suspendisse elementum, odio ac rhoncus tempus, dolor lacus consectetur lacus, quis congue mi sapien nec massa. Etiam convallis dolor massa, id iaculis dui suscipit quis. Sed quis nisl vel mi elementum blandit malesuada eu nibh. Donec sit amet turpis ut lacus rhoncus bibendum eget a nulla. Aliquam pretium elit vestibulum feugiat posuere. Nulla vel placerat lectus. Nullam consectetur bibendum fermentum. Praesent dignissim nunc quis dui lacinia aliquam. Vestibulum venenatis viverra tempor. Donec ullamcorper maximus sodales. Mauris ultricies nulla sed elit blandit imperdiet. Vestibulum ante ipsum primis in faucibus orci luctus et ultrices posuere cubilia curae; Donec porttitor bibendum mi, vel commodo turpis. Mauris nec justo efficitur, congue tortor non, ornare ligula. Fusce euismod arcu ut elit maximus, vitae porta odio cursus. Nam vitae mauris eu erat commodo dignissim. Integer dignissim volutpat consequat. Cras at vestibulum lectus, id pretium ligula. Fusce vitae congue nulla. Morbi blandit lectus a dui hendrerit sodales. Mauris id lectus nisl. Quisque iaculis cursus posuere. Nullam nec rhoncus velit. Donec vitae elit arcu. Sed molestie ipsum justo, sit amet ultricies ligula pretium egestas. Fusce bibendum porttitor felis sit amet elementum. Class aptent taciti porttitor.";
// the setup function runs once when you press reset or power the board
void setup() {
// initialize digital pin LED_BUILTIN as an output.
pinMode(LED_BUILTIN, OUTPUT);
Serial.begin(115200);
}
// the loop function runs over and over again forever
void loop() {
digitalWrite(LED_BUILTIN, HIGH); // turn the LED on (HIGH is the voltage level)
delay(250); // wait for a second
digitalWrite(LED_BUILTIN, LOW); // turn the LED off by making the voltage LOW
delay(250); // wait for a second
Serial.println(lorem);
}