STM32F030 custom board

If you made your own board, post here, unless you built a Maple or Maple mini clone etc
User avatar
ddrown
Posts: 126
Joined: Sat Jan 09, 2016 4:49 am

Re: STM32F030 custom board

Post by ddrown » Fri Feb 24, 2017 3:10 am

Update! I wrote two long things on my blog: https://blog.dan.drown.org/frequency-sy ... se-in-ntp/ + https://blog.dan.drown.org/temperature-compensation/

But some highlights:

Test system:

Image

Frequency vs temperature:

Image

Remaining error after removing the fit line from the previous graph:

Image

When the temperature goes down:

Image

My supply voltage goes up by 4mV:

Image

Bingo600
Posts: 9
Joined: Thu Mar 16, 2017 5:25 pm

Re: STM32F030 custom board

Post by Bingo600 » Thu Mar 23, 2017 8:23 pm

These are actually nice OCXO's
http://www.ebay.com/itm/NEW-10MHz-OCXO- ... 2308905189

DS
http://www.microcrystal.com/images/_PDF ... r/OCXO.pdf

Uses less than 80ma@20c , 300ma@startup (10 sec) , they're 5v supplied


This one seems to have somewhat same specs
http://www.ebay.com/itm/10MHz-OCXO-DIP- ... 2868381695
http://www.golledge.com/pdf/products/ocxos/scocxovt.pdf

/Bingo

User avatar
ddrown
Posts: 126
Joined: Sat Jan 09, 2016 4:49 am

Re: STM32F030 custom board

Post by ddrown » Thu Mar 23, 2017 8:50 pm

Bingo600 wrote:These are actually nice OCXO's
http://www.ebay.com/itm/NEW-10MHz-OCXO- ... 2308905189

DS
http://www.microcrystal.com/images/_PDF ... r/OCXO.pdf

Uses less than 80ma@20c , 300ma@startup (10 sec) , they're 5v supplied


This one seems to have somewhat same specs
http://www.ebay.com/itm/10MHz-OCXO-DIP- ... 2868381695
http://www.golledge.com/pdf/products/ocxos/scocxovt.pdf

/Bingo
Thanks, those are good specs. 150ppb stability over -20C to 70C is at least 16x better than what I'm using now.

However, I think I'm going to stick with the TCXOs for now. I'm pretty happy with the results I got by fitting the frequency vs Temperature data:

Image

After measuring the frequency vs temperature curve of these two boards, I increased my 2.5ppm part's stability to 0.036ppm.

more at: https://blog.dan.drown.org/temperature- ... on-part-2/

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest