My system is maxOs SIerra.
I used software:
1. git clone https://github.com/rogerclarkmelbourne/ ... loader.git
2. git clone https://github.com/rogerclarkmelbourne/ ... _STM32.git
a. Arduino uno reset pin to ground.
b. Arduino uno 3.3V to STM 3.3V , groung to ground
c. Arduino uno 0 (RX) and 1 (TX) to STM32 A9 and A10 (i try change pins between each other)
d. STM32 boot0 is power, boot1 is ground
and i try flashing like that
./stm32flash -w ../../../../STM32duino-bootloader/binaries/generic_boot20_pa9.bin /dev/tty.usbmodem1431
Code: Select all
Using Parser : Raw BINARY Error probing interface "serial_posix" Cannot handle device "/dev/tty.usbmodem1431" Failed to open port: /dev/tty.usbmodem1431
also i checked my arduino uno usb to uart, i used bluetooth and send AT command, it's work with same configuration.
Maybe somebody had solved this problem? Thank you.