Arduino IDE and Serial Monitor
Posted: Thu Dec 01, 2022 3:48 pm
I got the STM32 Board package installed and uploaded the blink program to my F446RE board and everything worked fine.
So I switched over to a simple calibration sketch for a MPU6050.
Sketch compiled and uploaded no issues.
Ran the sketch and the sketch ran.
The serial monitor shows the sketch and the serial.prints that print out text work correctly.
When it comes down to displaying the actual values from the calibration routine it displays and something other than numbers.
I ran the same sketch on an Arduino Uno and it printed the calibration numbers correctly.
Any thoughts on the cause or how to fix it?
Thanks!
So I switched over to a simple calibration sketch for a MPU6050.
Sketch compiled and uploaded no issues.
Ran the sketch and the sketch ran.
The serial monitor shows the sketch and the serial.prints that print out text work correctly.
When it comes down to displaying the actual values from the calibration routine it displays and something other than numbers.
I ran the same sketch on an Arduino Uno and it printed the calibration numbers correctly.
Any thoughts on the cause or how to fix it?
Thanks!