STM32F103C8 128K - USB unknow
Posted: Tue Apr 04, 2023 3:25 pm
Hello, so I'm new to the STM32 world and I'm encountering some problems.
I am trying to install the bootloader on my STM32, and I am following these steps religiously:
https://www.electronicshub.org/how-to-u ... ootloader/
I can successfully burn the bootlader on my STM using the ST Flasher tool, but when I try to upload the code on the Arduino IDE, I just don't see the COM, because my computer doesn't recognize it for some reason.
I don't understand why this is happening, as I have installed already the necessary drivers for it to recognize the port.
Thank you so much for your attention
I am trying to install the bootloader on my STM32, and I am following these steps religiously:
https://www.electronicshub.org/how-to-u ... ootloader/
I can successfully burn the bootlader on my STM using the ST Flasher tool, but when I try to upload the code on the Arduino IDE, I just don't see the COM, because my computer doesn't recognize it for some reason.
I don't understand why this is happening, as I have installed already the necessary drivers for it to recognize the port.
Thank you so much for your attention