Search found 6 matches
- Fri Jun 24, 2022 8:55 am
- Forum: STM32F4 based boards
- Topic: Arduino bootloader development
- Replies: 3
- Views: 5967
Re: Arduino bootloader development
based on the schematics https://github.com/FYSETC/FYSETC-SPIDER/blob/main/hardware/Spider%20V2.2%20SCH.pdf it uses the on-chip usb and the boot0 pin is on a header. so all you need is set boot0 reset and you can upload firmware using the on-chip usb over DFU no additional boot loader is needed. you...
- Fri Jun 24, 2022 6:22 am
- Forum: STM32F4 based boards
- Topic: Arduino bootloader development
- Replies: 3
- Views: 5967
Arduino bootloader development
Hello to everyone I bought this board https://github.com/FYSETC/FYSETC-SPIDER v2.2 in order to use it in a custom application and not as a 3D printer controller In my application i would like to have it connected to a PC over usb and get the data of the usb cdc serial but i can't seem to be able to ...
- Mon Aug 30, 2021 6:40 pm
- Forum: STM boards (Discovery, Eval, Nucleo, ...)
- Topic: SPI Bus wont work on Nucleo
- Replies: 4
- Views: 3845
Re: SPI Bus wont work on Nucleo
RTD value: 8545 Ratio = 0.26077271 Resistance = 112.13226318 Temperature = 31.15 It worked correctly over SW-SPI, i will try to fix HW-SPI but for now its not critical THANKS for all the information /*************************************************** This is a library for the Adafruit PT100/P1000 ...
- Mon Aug 30, 2021 6:32 pm
- Forum: STM boards (Discovery, Eval, Nucleo, ...)
- Topic: SPI Bus wont work on Nucleo
- Replies: 4
- Views: 3845
Re: SPI Bus wont work on Nucleo
Code: Select all
Ratio = 0.51989746
Resistance = 223.55590820
Temperature = 332.47
Fault 0x1
- Mon Aug 30, 2021 5:50 pm
- Forum: STM boards (Discovery, Eval, Nucleo, ...)
- Topic: SPI Bus wont work on Nucleo
- Replies: 4
- Views: 3845
Re: SPI Bus wont work on Nucleo
We found an issue using Adafruit libraries. it uses int8_t as type for pin but STM32 can have pin higher than 127 or alias pin PYn higher than 127. This is the case here. Try with Dx or x number instead of PYn. PA4 is defined as PIN_A22 as it has analog capabilities so higher than 127. It's digital...
- Sun Aug 29, 2021 7:25 pm
- Forum: STM boards (Discovery, Eval, Nucleo, ...)
- Topic: SPI Bus wont work on Nucleo
- Replies: 4
- Views: 3845
SPI Bus wont work on Nucleo
I have a problem, i am guessing at the framework level. I got a Nucleo-144 (H743ZI2) and some RTD readers featuring MAX31865 over SPI. I spend 2 days trying to debug why the SPI-DO whouldn't transmit any data. If i am correct MISO(DO) should be kept low and rise on data transmition? Datasheet Flow B...