Arduino for STM32

I got this figures out.

Series of errors on my part.

When I tested this with an Uno I loaded the wrong sketch so the sketch worked but it was the wrong sketch.

Don't I feel like an idiot.

After I loaded the correct sketch it did he same thing on the Uno.

I've cleaned up my project directories ...

I got the STM32 Board package installed and uploaded the blink program to my F446RE board and everything worked fine.

So I switched over to a simple calibration sketch for a MPU6050.

Sketch compiled and uploaded no issues.

Ran the sketch and the sketch ran.

The serial monitor shows the sketch ...

Thank you!

That worked.

I didn't even know that was a thing.

In case others have the same issue here is what I did:

In the file preferences is set the interface scale to 80%

Then the install button showed up
Thanks again for the help!

I ordered a couple of Nucleo F446RE boards just to try out and see what I can do with them.

I've been doing projects with Arduino boards for a while and figured it might be time to see what other boards are out there.

I'll admit I'm not the brightest bulb in the package especially when it comes to ...