I folllowed the steps in https://github.com/rogerclarkmelbourne/Arduino_STM32/wiki/Installation for Windows (10) but there is no Comport other than the one on the motherboard. I did do the install_drivers.bat as superuser.
In the device manager "Universal Serial Bus-controllers" there is an Unkown ...
Search found 4 matches
- Wed Jul 29, 2020 8:35 am
- Forum: Maple & Maple mini etc
- Topic: IDE does not see COM port
- Replies: 2
- Views: 18700
- Tue Jul 28, 2020 9:42 pm
- Forum: Maple & Maple mini etc
- Topic: Maple mini bricked
- Replies: 4
- Views: 16528
Re: Maple mini bricked
I did succesfully flash the maple_mini_boot20.bin file. So I can try (tomorrow) uploading some code.
Thanks. I connected boot0 to Vcc and boot1 to GND and after power-up pressed the reset and then I had connection.
Thanks. I connected boot0 to Vcc and boot1 to GND and after power-up pressed the reset and then I had connection.
- Tue Jul 28, 2020 8:58 pm
- Forum: Maple & Maple mini etc
- Topic: Maple mini bricked
- Replies: 4
- Views: 16528
Re: Maple mini bricked
I think I flashed generic_boot20_pc13.bin from https://raw.githubusercontent.com/roger ... 0_pc13.bin
- Sat Jul 25, 2020 8:47 pm
- Forum: Maple & Maple mini etc
- Topic: Maple mini bricked
- Replies: 4
- Views: 16528
Maple mini bricked
I received today a Maple Mini board and wanted to do some tests with it by programming it with the Arduino IDE.
So I searched Internet and found out that I had to flash another bootloader. So I installed Flash Loader Demonstrator and uploaded the bin file with a FT232. Then disconnected the FT232 ...
So I searched Internet and found out that I had to flash another bootloader. So I installed Flash Loader Demonstrator and uploaded the bin file with a FT232. Then disconnected the FT232 ...