Arduino for STM32

hobbya

The internal resistance of common multi-meter is around 10M and can affect voltage measurement if you choose high values for the potential divider.

hobbya

Please spend some time search and read properly before raising an unwise question.

https://github.com/stm32duino/Arduino_C ... ki/API#spi

hobbya

You are not alone regarding the frustration to enter DFU mode with STM32F411. There is a workaround below:
https://www.stm32duino.com/viewtopic.php?t=1680

Here is a bit explanation about the problem associated with HSI.
https://www.st.com/resource/en/application_note/an2606-stm32-microcontroller ...

hobbya

Yes your understanding is correct.
v2.1 has Tx/Rx pins which can be connected to the Bluepill serial port.

hobbya

I always use STLink v2.1. It comes with a virtual com port.
STLink v2 do not have the virtual com port.

Some more info here:
https://stm32world.com/wiki/DIY_STM32_Programmer_(ST-Link/V2-1)

Nucleo boards also has a built-in STLink v2.1 and it can be "broken off" from the board:
https://jeelabs ...

hobbya

So you have used Maple core.
If you use STM32 core, the JTAG pins PB3, PB4, PA15 will be released once you set them as output port:

Code: Select all

pinMode(PB3, OUTPUT);
pinMode(PB4, OUTPUT);
pinMode(PA15, OUTPUT);

hobbya

Not sure if the core you used was up to date. You can install the up to date version below:

Roger's original core:
https://github.com/rogerclarkmelbourne/Arduino_STM32 or
A fork of Roger's and is more frequently maintained:
https://github.com/stevstrong/Arduino_STM32

When picking options in ...

hobbya

Although the chips are not moisture-proof, I have not heard of any failures due to moisture trapped inside the chip. I do not keep my development boards within enclosures and I have not encountered failures after prolonged storage. Since your boards are partially functional, I suggest to investigate ...

hobbya

PB2 is Boot1 of the bluepill and generally a jumper is fitted. The Boot1 jumper is usually tied to LOW. You should either tie the jumper to HIGH or remove this jumper before running your code.

hobbya

Why have you made it so complicated?

No need to anything on SPI1. Just need to define the pins of SPI2 for your board.

#define SD_PIN PB12
#define SetSDSpeed 48

SPIClass SPI_2 (PB15, PB14, PB13); // for blackpill STM32F401 or bluepill STM32F103
#define SD_CONFIG SdSpiConfig (SD_PIN, DEDICATED ...

Arduino for STM32

Search found 49 matches

Re: Voltage divider on Nucleo STM32L452RE bad accuracy

Re: Missing SPI1 and SPI2 difinitions

Re: Program an STM32F411 with an Raspberry Pi

Re: SIMPLE QUESTION BLUE PILL COMMUNICATIONS SETTINGS

Re: SIMPLE QUESTION BLUE PILL COMMUNICATIONS SETTINGS

Re: tm1637 arduino ide library issues -----SOLVED----

Re: STM32F103C8T6 with u8g2 library problem

Re: Advice for baking STM32 ICs

Re: BluePill:PB2 state change not detected when connecting to ground - is my core out of date?

Re: SPI1 is in use, how can I use SPI2 for a MicroSD card?