Page 1 of 1

Possibility to update the STM32F4-Discovery ST-Link/V2 to V2-A

Posted: Tue Nov 24, 2020 5:50 am
by EmbedTux
Hello,

I look to start a project with my old STM32F4-Discovery board. If I'm not wrong, it is exactly the same as the new STM32F4-Dico1 board that support the ST-Link/V2-A. So, I don't understand why it seem not possible to update the ST-Link firmware to become a V2-A. I would like to get the VCP support.

Does anybody know if this is possible?

thanks!

Re: Possibility to update the STM32F4-Discovery ST-Link/V2 to V2-A

Posted: Tue Nov 24, 2020 3:33 pm
by mrburnette

Re: Possibility to update the STM32F4-Discovery ST-Link/V2 to V2-A

Posted: Wed Nov 25, 2020 12:25 am
by EmbedTux
Thanks MrBrunette.

I think I wasn't be clear enough. What I want, it is to have the ST-Link on the STM32F4-Dicovery board support the VCP to get the configuration shown in the section 6.1.3 of the user manual.
https://www.st.com/resource/en/user_man ... ronics.pdf

But the note (a) in the section 6.1 suggest that it is not available. But, I don't see why as both F4 discovery board seem to have the same schematic.

I tried to update the firmware of the ST-Link with the STM32CubeProgrammer and with the LINK007 update package.
https://www.st.com/content/st_com/en/pr ... nk007.html

In both case I end with the version V2J37S0 which is not listed in the release note. For the ST-Link/V2, it is supposed to be V2J37S7. Also, the ST-Link/V2-A is not mentioned either.

https://www.st.com/resource/en/release_ ... ronics.pdf