Sloeber IDE runs with core 1.7 but not with 1.8
Posted: Mon Feb 17, 2020 7:54 pm
Hello,
I tested the Sloeber IDE (based on Eclipse).
It runs very well for me and I can compile a quite complex sketch. Also the upload to Bluepill is running.
But only with the 1.7 core.
When I try to use the stmduino 1.8 core, there are a lot of errors.
Even a 'naked' sketch (only setup() and loop() ) without any code raises compiling errors.
Maybe that this is a sloeber issue... may it be caused by the update from CMSIS_5 to 5.6.0 ??
Has anyone some experience with sloeber?
regards
Kurtow187
I tested the Sloeber IDE (based on Eclipse).
It runs very well for me and I can compile a quite complex sketch. Also the upload to Bluepill is running.
But only with the 1.7 core.
When I try to use the stmduino 1.8 core, there are a lot of errors.
Even a 'naked' sketch (only setup() and loop() ) without any code raises compiling errors.
Maybe that this is a sloeber issue... may it be caused by the update from CMSIS_5 to 5.6.0 ??
Has anyone some experience with sloeber?
regards
Kurtow187