I am am an arduino beginner. I have made up several arduino nano based projects based on shared sketches. I have edited sketches, but never wrote any from scratch and probably never will.
I am about to order a STM32 board and take on making one of these YMFC-32 quadcopters.
http://www.brokking.net/ymfc-32_main.html
Any tips or suggestions that will assist will be most welcome.
I have opened a thread over on rcgroups specifically for this project.
https://www.rcgroups.com/forums/showthr ... -questions
Should be fun!
Jim
Bellingen NSW Australia.
My first post on this forum.
Re: My first post on this forum.
Hi and welcome.
Unfortunately, I have no experience on this subject.
Anyway, if I can help I will do.
Unfortunately, I have no experience on this subject.
Anyway, if I can help I will do.
Re: My first post on this forum.
Hi, I just arrived here. New bee.
I'm also working on Drone...
Nice to see you..
I'm also working on Drone...
Nice to see you..
Re: My first post on this forum.
How is your project going? I too am trying to duplicate the brokking project. I branched out a bit from his 6050 tutorial where he uses the arduino Uno mostly. That went well. A few days ago I started his autonomous drone project and am getting a bit hung up using the add on system for uploading the program to the chip.
Did that part go smooth for you? Since I am using a Mac and the brokking.net stuff is PC I am getting a few incompatabilities...
Hoping for some news,
Paz
Did that part go smooth for you? Since I am using a Mac and the brokking.net stuff is PC I am getting a few incompatabilities...
Hoping for some news,
Paz