Page 1 of 1

My first post on this forum.

Posted: Fri Jun 12, 2020 10:20 am
by Jim0000
I am am an arduino beginner. I have made up several arduino nano based projects based on shared sketches. I have edited sketches, but never wrote any from scratch and probably never will.
I am about to order a STM32 board and take on making one of these YMFC-32 quadcopters.

http://www.brokking.net/ymfc-32_main.html

Any tips or suggestions that will assist will be most welcome.
I have opened a thread over on rcgroups specifically for this project.

https://www.rcgroups.com/forums/showthr ... -questions

Should be fun!

Jim
Bellingen NSW Australia.

Re: My first post on this forum.

Posted: Fri Jun 12, 2020 12:17 pm
by fpiSTM
Hi and welcome.

Unfortunately, I have no experience on this subject.
Anyway, if I can help I will do.

Re: My first post on this forum.

Posted: Sat Jun 20, 2020 5:07 pm
by doojin
Hi, I just arrived here. New bee.
I'm also working on Drone...
Nice to see you..

Re: My first post on this forum.

Posted: Mon May 17, 2021 5:02 pm
by PazHeping
How is your project going? I too am trying to duplicate the brokking project. I branched out a bit from his 6050 tutorial where he uses the arduino Uno mostly. That went well. A few days ago I started his autonomous drone project and am getting a bit hung up using the add on system for uploading the program to the chip.

Did that part go smooth for you? Since I am using a Mac and the brokking.net stuff is PC I am getting a few incompatabilities...

Hoping for some news,
Paz