Arduino for STM32

Hi everyone,

I'm a young electronic engineer even though in my professional life I fiddle a bit with everything (from real time software to analogue electronics, jack of all trades, master of none). I'm also an electronic enthusiast and I like to spend my free time designing and building small systems like a custom throttle quadrant for WWII flightsim, or a "music box" for a friend of mine.

I participated twice in the robotic French cup, and during my last participation in 2016 a STM representative gave me a nucleo 64 (L053R8) that I've been neglecting since then.

Recently I've run out of Arduino (too much free time during the covid-19 outbreak) and decided to give the nucleo 64 its chance. So far it didn't go that well and that's why I'm here.

I thank you in advance for your welcome.

Bacab wrote: ↑Fri Jun 26, 2020 6:47 pm ...
Recently I've run out of Arduino (too much free time during the covid-19 outbreak) and decided to give the nucleo 64 its chance. So far it didn't go that well and that's why I'm here.
...

Welcome to the forum. The good news is that your board is fully supported see here.

Moving from 8-bit Arduino AVR into 32-bit ARM can be a little rough; for example int is no longer 16-bit but 32-bit. Little things like that is a P.I.T.A. Maybe try a few examples and expect some port issues with older libs.

Ray