GRBL STM32duino?
Posted: Thu Feb 06, 2020 5:09 pm
After fighting (G31 probe command ) with really bad designed and closed source USB-parallel Adapters for my CNC (in particular: NC200 / RTM200) and due the fact, that GRBL is using the old fashioned ATmega328 i researched a bit about a GRBL conversation for ARM (better STM32), but I'm a little bit disappointed:
The ARM development seemed to be fell asleep for more than 3 years ( https://github.com/usbcnc/grbl) and the only STM32 thing I found on the old forum:
https://stm32duinoforum.com/forum/viewt ... rt_10.html
https://github.com/Alfrederson/cncstm32
So, I try to sum up:
Is anybody using a STM32 for a CNC?
Is anybody using GRBL on STM32?
Is anybody using 'GRBL on stm32duino?
The ARM development seemed to be fell asleep for more than 3 years ( https://github.com/usbcnc/grbl) and the only STM32 thing I found on the old forum:
https://stm32duinoforum.com/forum/viewt ... rt_10.html
https://github.com/Alfrederson/cncstm32
So, I try to sum up:
Is anybody using a STM32 for a CNC?
Is anybody using GRBL on STM32?
Is anybody using 'GRBL on stm32duino?