libmaple core found 'in the wild' - on 3d printer boards

Post here first, or if you can't find a relevant section!
Post Reply
ag123
Posts: 238
Joined: Thu Dec 19, 2019 5:30 am

libmaple core found 'in the wild' - on 3d printer boards

Post by ag123 »

as 3d printer boards running marlin
viewtopic.php?f=21&t=34#p157

on aliexpress
https://www.aliexpress.com/wholesale?ca ... t=skr+mini
https://www.aliexpress.com/store/718232 ... 436fkhDexz

the manufacturer's web
http://www.bigtree-tech.com/
and github
https://github.com/bigtreetech
stm32f407zg based
https://github.com/bigtreetech/BIGTREETECH-SKR-PRO-V1.1
STM32F103RCT6 based
https://github.com/bigtreetech/BIGTREET ... -MINI-V1.1

the new recent ones seemed to be these - check the last commits, very recent!
https://github.com/bigtreetech/BIGTREETECH-SKR-mini-E3
https://www.aliexpress.com/item/33044387438.html
https://www.aliexpress.com/item/33042554065.html
for some unknown reasons the manufacturer went with lpc for another board rather than offer an f4 board :lol:

it isn't necessarily a 'bad thing' as this time round we can literally buy a stm32f103 or stm32f407 3d printer board off the shelf, complete with vendor support and open sourced firmware :mrgreen:

it seemed the 'pill' boards (& maple mini's ) are 'growing up', more than likely the boards may no longer be just a dev board (it isn't all that difficult to run a washing machine with a stm32) :lol:

Post Reply

Return to “General discussion”