Arduino for STM32

Posted: **Thu Jan 14, 2021 4:28 am**

Assuming the schematic is for a carrier board that holds the blue pill board, I would first power the blue pill separately and just hook up the sensor. If that works, I would hook up the other used pins one at a time until the problem reappears.

I read somewhere that the pins going to the crystals needed to be removed before plugging into another circuit.

Posted: **Thu Jan 14, 2021 1:34 pm**

Are you "really" supplying +5V from DC-DC to the 3.3V uC as shown in the schematic?

Posted: **Fri Jan 15, 2021 4:44 am**

mrburnette wrote: Thu Jan 14, 2021 1:34 pm Are you "really" supplying +5V from DC-DC to the 3.3V uC as shown in the schematic?

yeaaa

Posted: **Fri Jan 15, 2021 6:16 am**

thanks all, finally I can overcome this issue by changing the wire cable of my sensor

I just cut it off and replace it with the new one

Arduino for STM32

[SOLVED] Temp sensor DS18B20 on STM32 sometimes read 85

Re: Temp sensor DS18B20 on STM32 sometimes read 85

Re: Temp sensor DS18B20 on STM32 sometimes read 85

Re: Temp sensor DS18B20 on STM32 sometimes read 85

Re: [SOLVED] Temp sensor DS18B20 on STM32 sometimes read 85