STM32 BOOTLOADER
Posted: Wed Apr 06, 2022 11:15 am
I have recently gotten a F411 board. What's more, was keen on booting from USB.
I can transfer programs through Serial or SWD alright. Yet, USB gives blunders.
Certainly the boot load activity will be something similar. Just with an alternate vehicle.
Any Flash program or confirmation mistakes would show up paying little heed to ship.
Whenever the board showed up I was unable to enter USB Boot mode by means of BOOT0 and RST buttons.
I associated by means of SWD and did a "Mass Erase" to clear any firmware that accompanied the board.
Some of the time I can get STM32 BOOTLOADER yet generally "USB gadget not perceived"
In the event that I in all actuality do figure out how to get the USB DFU transfers come up short. Both with Arduino and with STM32CubeProgrammer
I can transfer programs through Serial or SWD alright. Yet, USB gives blunders.
Certainly the boot load activity will be something similar. Just with an alternate vehicle.
Any Flash program or confirmation mistakes would show up paying little heed to ship.
Whenever the board showed up I was unable to enter USB Boot mode by means of BOOT0 and RST buttons.
I associated by means of SWD and did a "Mass Erase" to clear any firmware that accompanied the board.
Some of the time I can get STM32 BOOTLOADER yet generally "USB gadget not perceived"
In the event that I in all actuality do figure out how to get the USB DFU transfers come up short. Both with Arduino and with STM32CubeProgrammer