ST-Link V2 on macOS Monterey with M1 Chip
Posted: Fri Jul 15, 2022 2:28 pm
Hi everybody,
does anybody know how to operate the ST-Link V2 on macOS Monterey with M1 Chip?
I'm using the Arduino IDE 1.8.19 and have installed the Sduino STM8 plain C core.
All is fine, I can choose the correct board and the programmer.
I can successful compile the sketch but no upload to the device, a common STM8SF103F3P6, is possible.
I just get the info, that no programmer is installed.
Thanks for your support!
Rainer
does anybody know how to operate the ST-Link V2 on macOS Monterey with M1 Chip?
I'm using the Arduino IDE 1.8.19 and have installed the Sduino STM8 plain C core.
All is fine, I can choose the correct board and the programmer.
I can successful compile the sketch but no upload to the device, a common STM8SF103F3P6, is possible.
I just get the info, that no programmer is installed.
Thanks for your support!
Rainer