Two Arduino IDE'S, two STLINK'S simultan
Posted: Sun Jul 24, 2022 11:36 am
Hi,
I,m using two (portable) Arduino IDE's with two STLINK V2 in exchange.
One IDE with Bluepill, one with a STMF411.
I use this with at one USB Hub with switchable USB channels.
Each IDE has its own cache folder.
This runs nearly perfect. But...
If I ever forget to activate/deactivate the correct USB port, then the wrong processor is flashed (with the wrong software).
(this happens quite often since I'm not the youngest anymore)
So my questions are:
- Does anyone know the way to adress the STLINK via the Arduino IDE via the serial number?
- It is possible create your own command line for the Arduino CLI?
- Is it possible to find the command line generated by the IDE on the computer?
I am grateful for any help!
Kurtow
I,m using two (portable) Arduino IDE's with two STLINK V2 in exchange.
One IDE with Bluepill, one with a STMF411.
I use this with at one USB Hub with switchable USB channels.
Each IDE has its own cache folder.
This runs nearly perfect. But...
If I ever forget to activate/deactivate the correct USB port, then the wrong processor is flashed (with the wrong software).
(this happens quite often since I'm not the youngest anymore)
So my questions are:
- Does anyone know the way to adress the STLINK via the Arduino IDE via the serial number?
- It is possible create your own command line for the Arduino CLI?
- Is it possible to find the command line generated by the IDE on the computer?
I am grateful for any help!
Kurtow