Hi from Poland
Posted: Wed Nov 23, 2022 2:53 pm
Hello Everybody!
My name is Jarosław.
I am creating our own small projects basen on BluePill and also with original arduino boards. I am using stm32duino for these project mostly with success.
Now I am starting build a little bigger project to automate my home.
In my treasure chest I found a Netduino Plus 2 board and I would like to run it by writing code in arduino.
I am pretty sure that the problem that brings me here was solved on old forum but I can not find fully information.
It is about the 25MHz clock for ENC28J60 from MCO1 (PA8).
Kind regards
Jarosław
My name is Jarosław.
I am creating our own small projects basen on BluePill and also with original arduino boards. I am using stm32duino for these project mostly with success.
Now I am starting build a little bigger project to automate my home.
In my treasure chest I found a Netduino Plus 2 board and I would like to run it by writing code in arduino.
I am pretty sure that the problem that brings me here was solved on old forum but I can not find fully information.
It is about the 25MHz clock for ENC28J60 from MCO1 (PA8).
Kind regards
Jarosław