Arduino for STM32

Hello I'm an IoT developer who also tries to get students enthusiastic about IoT.
I would like to share my latest project, a LoRa node with stm32L051C8T6 controller and BME sensor running in Low Power.

Short list of features:

• Arduino code is used, combined with STM32 HAL code;

• It’s a generic development board, hence the name MiniPill, a wink to the BluePill board. Without the RFM95 chip it can be used for other projects;

• The LMIC library is used for the LoRaWAN protocol with OTAA as connection setup instead of ABP;

• Due to this library it is possible to downlink data to the node and get confirmation of the received data;

• In Low Power Mode: 1.9 uA during sleep period;

• With a BME280 sensor beside temperature and humidity also pressure can be measured and send through LoRaWAN;

• Enough pins are available for other sensors or actuators;

• Due to a 4 layer SMT print and SMT components the print is smaller but has an other form-factor. The size is 33.1 mm x 22.9 mm;

• Pinouts are labeled and 4 VCC and GND connectors are available for external sensors.

Please checkout this post on my blog: https://www.iot-lab.org/blog/370/.

Leo.

Thanks for sharing. Nice project