Arduino for STM32

Try with to add that in your setup()

I think I went on a wrong direction looking at the BSY flag...
Looking at the oscilloscope, I have the following result with the Arduino:
SDS00012.png

And I have that using the STM32:
SDS00010.png

As they suggest here, I might need to reset the SPI pin before using it: https://electronics ...

I've seen in an errata from ST that my µC is subjected to problem with the BSY bit in the SPI protocol (note that I don't really understand what it means :D )
2.13 SPI
2.13.1 BSY bit may stay high when SPI is disabled
Description
The BSY flag may remain high upon disabling the SPI while operating ...

On the STM32G4 Nulceo user manual, it's written that by default, T_SWO is connected to PB3 (SPI1_CLK). https://www.st.com/resource/en/user_manual/um2397-stm32g4-nucleo32-board-mb1430-stmicroelectronics.pdf p.17
Could that T_SWO interfere with the SPI?
If I remove the solder bridge (SB4), would I ...

Hi all,
For I project, I would like to switch from an Arduino Nano to a Nucleo-G431KB.
I use a pressure sensor HRCDRRN100MDSA3 from Honeywell, with the HoneywellTruStabilitySPI library.

Using the Arduino, I have no problem to run the exemple code.

But I can't made it work with my Nucleo, even with ...

Hi all!
I'm Gauthier, working for a french mechanical company, and just joining the STM32 side of the world for my work project!
I'm not a µC controller professional, but I have discovered the basics with Arduino.

For my project I need to go way faster, so I just bought Nucleo to try!