Arduino for STM32

BlackPill F401CC is for boards with 25MHz crystal
Generic F401CCUx is for boards with 8MHz crystal

You must select "USB support->CDC (generic Serial supersede U(S)ART)" from menu or "Serial" will on serial port (PA9/PA10), not as recognizable USB device.
Clipboard01.jpg
If you still can't see ...

You can try to install this:
https://www.st.com/en/development-tools/stsw-link009.html


Thanks I downloaded this and installed it. Made no difference I still have no COM port assigned to the STM32 in Device Manager. I should have noted STM32 Cube Programmer is installed.

This is with the ...

You can try to install this:
https://www.st.com/en/development-tools/stsw-link009.html


Thanks I downloaded this and installed it. Made no difference I still have no COM port assigned to the STM32 in Device Manager. I should have noted STM32 Cube Programmer is installed.

This is with the STLink ...

Maybe I have asked this question in the wrong forum as this is a Windows driver issue not an Arduino IDE issue. I have no problem loading sketches to the STM32

I have loaded the STM32 in Board Manager and it uses the STM32F401CC. I can compile and load sketches to the STM32.

The issue is I have is ...

I am in the process of designing an FOC controller for a PMS motor. Using the STM32F401CCU Black Pill.

The environment is as follows
Windows 7 PC
Arduino IDE V 1.8.19
SimpleFOC driver V 2.0.4

I tried uploading pics here but by the time I resized them they were eligible, so I uploaded them in this ...