Page 1 of 1

STEVAL-MKSBOX1V1 - SensorTile.box

Posted: Wed Jan 15, 2020 2:35 pm
by zoomx
A friend of mine borrowed me an STEVAL-MKSBOX1V1 - SensorTile.box
https://www.st.com/en/evaluation-tools/ ... ox1v1.html

I started playing with the associated app for Android (but there is the iOS also).

Looking forward to write more complex application I foud that is supported in the ST core.
But I found also that if i want to use BLE I have to reflash the BLE chip. To flash chip I have to solder a SWD 0.05" pitch 10pin male connector in the apposite space of the PCB.

So at this moment I am playing only with the app.

Re: STEVAL-MKSBOX1V1 - SensorTile.box

Posted: Wed Jan 15, 2020 4:15 pm
by fpiSTM
Right.
The default firmware does not support LL only mode...