STM32H723
Posted: Sat Jan 27, 2024 2:45 am
I am trying to upload my own code to a BTT SKR 3 board, originally made for 3D printing. I thought it had everything I needed for my custom project.
https://biqu.equipment/products/bigtree ... 3d-printer
I am trying to upload some basic blink code to test it out but running into issues.
I seem to be able to upload a basic sketch using DFU mode after also installing "STM32CubeProgrammer v2.15.0" However after upload the serial line no longer connects, the pin doesn't blink either.
I can get back to DFU mode but can't seem to get the serial to come back.
I am trying to figure out the proper settings for uploading. Any suggestions appreaciated!
https://biqu.equipment/products/bigtree ... 3d-printer
I am trying to upload some basic blink code to test it out but running into issues.
I seem to be able to upload a basic sketch using DFU mode after also installing "STM32CubeProgrammer v2.15.0" However after upload the serial line no longer connects, the pin doesn't blink either.
I can get back to DFU mode but can't seem to get the serial to come back.
I am trying to figure out the proper settings for uploading. Any suggestions appreaciated!